The ryobi band saw, used for jobs of all sizes. It has many uses such as cutting wood, plexiglass, and gives you the exact cut you need.
The irwin clamp is used to hold your work down while sawing or cutting, not for billy to try to see how much pressure his finger can take.
The wagner heat gun can heat things up to 2,000 degrees farenheit. DO NOT TOUCH METAL TIP!!!!!!!
The high voltage band saw is very hungry! Billy should probably not attempt.
The diablo table saw blade isn't just hungry, its starving.
The brand new bandsaw is out of order due to an engine failure. It was made in china.
You can tell that the heat gun has been used a lot for its past years. Also along with the dremmel tool along side it.
All ready to put the finishing touches on my picture frame... Going to paint it green.
Today we learned how to use the new air powered metal cutter. It will cut metal anywhere from 3/5 of an inch thick to 2 inches thick.
Getting ready to use the new circular saw. It will cut anything with 220 volts of power.
Today we successfully tested out the new plastic forming machine. it works by vacuum-forming hot plastic onto a mold at a temp of 450 degrees Fahrenheit.
Id say that this plug is about twelve feet in the air. No one can get it back down.
The new plastic forming machine was opened up today. this is the heating mechanism inside. it works on the same principles as a toaster.
Getting ready to form the mold for my Magnetically levitated train. Also, mike Hannah attempts to use a tin foil mold.
The plastic is getting very HOT. DO NOT TOUCH
Success on one side, failure on the other. You decide which is which.
Mold is officially complete. now for the bottom of the train.
Finished placing the magnets correctly and got my train to float today. Now it just needs some metal work.
Adding aluminum to the sides to reduce friction. Hopefully it counteracts weight.
Today there was a failure with the heat gun. It ended with a badly burned table.